To set the sync operation(Create or Update or Both) at each field level, please select the appropriate Sync Operation on the Field Configuration popup. Based on the selection, the field has to be sent to sync either for create or update or both. 

This parameter is completely dependent on the Sync Operation under Entity Mapping where we can select at each application level. If at application level Create is not selected and only Update is selected, then at field level even when the Create is selected, then field will not be created. Also, this parameter depends on the Sync Direction as well.

After saving the Data type and Sync Operations at the field level, the same can be viewed in the view application link screen by clicking on this icon  (  ) under Field Properties section. 

 


The below table explains the result when you choose ‘Create’ at an app-level or at a field-level or in both.

Create

App Level
Field Level
Result
CheckedCheckedThe field will be set when the record is created in the destination application.
Un-CheckedUn-CheckedThe field will not be set when the record is created in the destination application.
CheckedUn-CheckedThe field will not be set when the record is created in the destination application.
Un-CheckedCheckedThe field will not be set when the record is created in the destination application. 


The below table explains the result when you choose ‘Update’ at an app-level or at a field-level or in both.

Update

App Level
Field Level
Result
CheckedCheckedThe field will be updated in the destination application, when the record is updated in the source application. 
Un-CheckedUn-CheckedThe field will not be updated in the destination application, when the record is updated in the source application. 
CheckedUn-CheckedThe field will not be updated in the destination application, when the record is updated in the source application. 
Un-CheckedCheckedThe field will not be updated in the destination application when the record is updated in the source application.